[Britomartis]

<p>Hi Martin.  I tried to get these about two years ago but drew a blank.  Eventually I was able to obtain a short length of SS angle from a steel stockholder I found on the web.</p>
<p>The most difficult bit in making them was forming the swaged area in the slot for the adjustable locking nuts.</p>
<p>I found that drilling the hole first which I then used a 14 mm drill bit (not the cutting end) as a punch to drift out the required amount of depression to accept the chamfered locking nut.  After that is done you can cut the slot and drill the other bolt holes.  Good luck.</p>
<p>Norman Drinkwater</p>